After adding an Intel AX210 WIFI/BT module to my mars board in the m2 e key slot, I was unable to boot and received this message below. Am I missing some onboard configuration for my WIFI module?
U-Boot 2021.10 (Jul 22 2023 - 09:37:08 +0000)
CPU: rv64imacu
Model: Milk-V Mars
DRAM: 4 GiB
MMC: sdio0@16010000: 0, sdio1@16020000: 1
Loading Environment from SPIFlash... SF: Detected gd25lq128 with page size 256 Bytes, erase size 4 KiB, total 16 MiB
*** Warning - bad CRC, using default environment
StarFive EEPROM format v2
--------EEPROM INFO--------
Vendor : MILK-V
Product full SN: MARS-V11-2340-D004E000-0000083A
data version: 0x2
PCB revision: 0xc1
BOM revision: A
Ethernet MAC0 address: 6c:cf:39:00:85:cb
--------EEPROM INFO--------
In: serial
Out: serial
Err: serial
Model: Milk-V Mars
Net: eth0: ethernet@16030000, eth1: ethernet@16040000
Card did not respond to voltage select! : -110
bootmode flash device 0
Card did not respond to voltage select! : -110
Hit any key to stop autoboot: 0
Card did not respond to voltage select! : -110
Couldn't find partition mmc 0:3
Can't set block device
Importing environment from mmc0 ...
## Info: input data size = 3829 = 0xEF5
## Error: "boot2" not defined
Card did not respond to voltage select! : -110
Couldn't find partition mmc 0:3
Can't set block device
## Warning: defaulting to text format
Card did not respond to voltage select! : -110
starfive_pcie pcie@2C000000: Starfive PCIe bus probed.
PCI: Failed autoconfig bar 10
ethernet@16030000 Waiting for PHY auto negotiation to complete......... TIMEOUT !
phy_startup() failed: -110FAILED: -110EQOS_DMA_MODE_SWR stuckFAILED: -110ethernet@16030000 Waiting for PHY auto negotiation to complete......... TIMEOUT !
phy_startup() failed: -110FAILED: -110EQOS_DMA_MODE_SWR stuckFAILED: -110StarFive # <INTERRUPT>
Removing the wifi module allows the mars board to boot correctly.